-
1. Introduction
-
1. Start
2. Target group
3. Learning objectives
4. Course length
5. Learning objectives test
6. Responsibility and consequences
7. Scope of the Code of Practice (CoP)
8. What is a Cargo Transport Unit (CTU)?
9. What is a load unit and what are the requirements?
10. Combined transport
11. Roles and responsibilities
12. Roles, responsibilities and laws
13. Exercise
-
2. Basic requirements
-
1. Start
2. Introduction
3. Stopovers and loads for "worldwide" transport
4. Basic preparation/General obligations
5. Duties of packers
6. Planning
7. Packing - general
8. Packing - Orders
9. Packing dangerous goods
10. Securing the load
11. After packing
12. Unpacking or unloading the CTU
13. Exercise
-
3. Responsibility and liability
-
4. Loads for land and sea transport
-
1. Start
2. Introduction
3. Average wave height at sea
4. Transport loads for sea transport
5. Why does inadequate load securing not always lead to damage?
6. Transport loads for road transport
7. Transport loads for rail transport
8. Handling load - Container bridge
9. Handling load - Van Carrier
10. Exercise
-
5. Characteristics of carriage of goods units
-
1. Start
2. Introduction
3. Information for senders and packers
4. Definition of container (ISO 668)
5. Container: strength and load
6. Container: markings
7. Container: ventilation openings
8. Container: lashing point
9. Container: lashing strap strength
10. Container: load distribution and line loads
11. Container: the line load is too high, what can be done?
12. Container: loads on container floors
13. Loads for vehicle structures
14. Vehicle: marking the structure
15. Traction and form fit
16. Calculation of the stability of the vehicle structure, example 1
17. Calculation of the stability of the vehicle structure, example 2
18. Calculation: stability of the vehicle structure/load securing
19. Calculation of the stability of the vehicle structure, example 3
20. Calculator: determine the number of straps
21. Swap body
22. Exercise
-
6. Inspection of CTUs
-
7. Training
-
8. Learning objectives test
-
9. Further information
Packing dangerous goods
- Check that the packages are properly marked and labelled.
- Observe the provisions for the stowing and mixed loading of dangerous goods.
- If only a portion of the load corresponds to dangerous goods, load these packages in the door area if possible.
- Make sure that the CTU is marked for the specific mode of transport (road, rail, sea).
- If you or other people load dangerous goods into a CTU, appropriate training is required.
- Do not load any damaged packages or goods into the CTU.
